INCIDENT REPORT:0007. Baseline Held. PROGRESS: 15 out of 100.

 

Bender-Bot, the Bender’s Club mascot, overlooks Boise, Idaho while smoking a cigar—an industrial robot embodying Kevin Wikse’s strength discipline and Industrial Strength Bastardry.
Bender-Bot surveys Boise—systems steady, baseline held. Strength earned through discipline. Industrial Strength Bastardry by Kevin Wikse.

I’m finally settled. Today marks the first official “normal” Monday back in Boise, Idaho.

The weekend was active. A lot of work got done—helping a friend move into a new apartment, clearing out a garage, plenty of heavy lifting. Productive, but taxing. In the background, I was already running the question: how will the Bender Bar feel after this?

The answer arrived immediately.

The first bend was difficult. I got it, but the initial energy expenditure was significant. Either my force vectors weren’t perfectly aligned, or residual fatigue was still present in the system. Possibly both.

Bends two through thirteen felt standard. Predictable. On bend fourteen, however, I felt my strength begin to falter—a breakdown somewhere in the circuit. Not catastrophic, but noticeable.

At that point, I knew there would be no new PR today. Worse, there was a real possibility of missing baseline.

That wasn’t acceptable.

After a significant additional effort, I locked in bend fifteen. 

No backslide.

That’s a win on its own.

OUTCOME: Baseline held under fatigue.
SYSTEM NOTE: Capacity intact. Calibration required.

I now look ahead to Friday. The focus shifts to a measured dial-in—tightening alignment, refining output, focusing the servos—to pursue bend sixteen. 


-Kevin Wikse, Industrial Strength Bastardry 
Location: Boise, ID, USA

Comments

Post a Comment

Popular posts from this blog

The 100 non-stop bends using a 100kg / 220lb Bender Bar Directive with Kevin Wikse.

This project documents my pursuit of 100 non-stop bends using a 100kg / 220lb Bender Bar , also known—for reasons known only to third-world marketing departments—as the Power Twister . This is a first-of-its-kind strength and endurance trial by fire and steel, intended to explore and demonstrate higher tiers of human capability through the development of android-like work capacity .. PARAMETERS & PROTOCOLS Overhand bending is the current operational standard. (Underhand bending will be addressed later. Not now.) The bar is held level at all times , ensuring the most honest possible display of strength and endurance. No long pauses. This is a simultaneous test of power and energy—output and volume, strength and stamina. The bar handles must touch for a bend to be counted as successful. It is feasible that the bar may slip or roll. If safe, I will adjust and continue. Control is preferred; awareness is mandatory. The bar remains in my hands at chest level ...
Read more

INCIDENT REPORT 0001: The Day After Christmas. PROGRESS: 11 out of 100.

12/26/2025 Day after Christmas. Last thing on my agenda was bending the 100kg / 220lb Bender Bar—also known as the Power Twister, a name that feels like it was approved by a 3rd world marketing department that never touched one. I was already wrecked. Hundreds of reps logged earlier for another project. Everything hurt. No mystery there. I’ll be honest: I had to dig deeper than usual to find a reason to step back under the bar. But the goal doesn’t care about holidays, soreness, or good intentions. It only recognizes completion. I locked in 11 solid bends . They hurt. Every single one. No drama, no surprise. Pain was the point of contact. But art—like strength, like anything worth having—doesn’t arrive gently. It’s extracted. Paid for. Usually in installments of suffering. - Kevin Wikse , Industrial Strength Bastardry 
Read more